Breadcrumbs
- You are here:
- Home
- Forums
- DIscussions
- Tech Help
- Rear windows
Rear windows
- Matt Gunsch
- Offline
Less
More
- Posts: 453
13 Dec 2018 10:03 #1
by Matt Gunsch
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook
Replied by Matt Gunsch on topic Rear windows
I have put them in before, don't try it on a cold day. put the gasket around the opening and slowly work the window into the gasket, some gaskets have a "locking ring" pressed into one side, remove that ring then reinstall after the window is in.
A&P, IA, PPSEL
too many years GA and Warbird Maint
Check out the Ercoupe Discussion group on facebook
Please Log in or Create an account to join the conversation.
- JIM OVERBECK
- Topic Author
- Offline
Less
More
- Posts: 2
11 Dec 2018 10:43 #2
by JIM OVERBECK
Rear windows was created by JIM OVERBECK
My name is Jack, and I am helping a friend restore a ercoupe. It started life as a C model, but has had so many mods it might a D or E etc. Both of the back windows were cracked. Large, I think Forny. I bought new ones from LP Aeroplastics, and new gaskets from univair. for the life of me I can’t figure out how to install them. Can you give me any pointers or a source of information on how to accomplish this task
Jack Mullenmaster
This email address is being protected from spambots. You need JavaScript enabled to view it.
920 572 0999
Jack Mullenmaster
This email address is being protected from spambots. You need JavaScript enabled to view it.
920 572 0999
Please Log in or Create an account to join the conversation.
Time to create page: 0.124 seconds